How to clean black kadai: During cooking every day, the pan is affected by oil, spices, smoke and gas flame. Gradually a thick layer of blackness accumulates on its outer surface. At first, this layer is light, but over time it becomes so hard that it is difficult to remove it with regular soap and detergent. Many people consider an old frying pan useless and decide to change it, when by following the right method they can make it shine again. The method shared by Sarabjit Kaur on social media has been discussed a lot these days. With the help of this trick, you can even make your old black pan look like new.

First, heat the pan well
Before starting the process of cleaning the frying pan, it is important to heat it well on gas. Heat the pan over high heat until light smoke begins to emerge from it. By doing this, the old soot and solid layer of oil on the pan starts to break down. When the pan is hot enough, turn off the gas. It is very important to be careful while doing this because the pan will be very hot. The purpose of this step is to facilitate the following cleaning process.

Remove thick soot first
Keep the hot pan in a safe place and then try to remove the thick soot with the help of a sharp knife or a strong scraper. Due to the heat, soot begins to come off like dandruff. Meanwhile, pay special attention to the back and sides of the pan because most of the soot accumulates there. The more old layer is removed in this step, the easier further cleaning will be.

Prepare a caustic soda solution
Now comes the special trick for which this method is being discussed. Fill a sturdy plastic bucket with hot water and add about three teaspoons of caustic soda. Caustic soda is a strong chemical, so it is important to be very careful while using it. While preparing the solution, wear rubber gloves and mix the water with a wooden or plastic stick. Never touch this solution with bare hands. Safety is extremely important.

Leave the pan in the solution for a few hours
When the solution is ready, carefully place the pan in it. Try to keep the pan completely submerged in water. After that leave it like this for 2 to 3 hours. During this time the caustic soda begins to affect soot and grease. Sometimes the pan looks darker than before but this is part of the normal process. There is no need to panic.

Clean with steel wool
After a few hours, remove the pan from the solution and wash it well with clean water. Be careful not to leave any traces of caustic soda on the pan. Now take a strong steel wool and put a little dishwashing liquid on it and start scrubbing the pan. At this time you will feel that the soot comes out much easier than before. The surface of the pan will start to become clean without much effort.

The sandpaper will give the final shine
If you want to make the pan look like new, you can use sandpaper in the last step. Gently rub the sandpaper over the inside and outside surfaces. By doing this for about 10 minutes, the remaining stains and marks also start removing. After that, wash the pan again with dishwashing liquid and clean it well with clean water.

Take these precautions while using caustic soda
Caustic soda is very effective in cleaning but it is also a strong chemical. Therefore, always wear gloves while using it. Keep it away from children and pets. While preparing the solution, do not get it too close to the face and use it only in a well-ventilated area. If it accidentally comes into contact with skin, wash it immediately with clean water. It is very important to follow safety rules.

Give new life to an old pan instead of throwing it away
People often think that a black pan is no longer of any use, but after proper cleaning, the same pan can look like new again. With a little hard work and the right approach, you can bring back the shine of your old pots. If you’ve had a frying pan in your kitchen covered in soot for years, definitely try this trick. The difference will be obvious if cleaned properly.